Page 2 of 4
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 27 Dec 2020, 12:53
by Philipp Gross
Excellent job on the weathering Michael!
I've never seen grey bombs before - I guess Navy and Army Air Force each did their own thing? Funny how battered they look, you'd think the crews would be more careful
Philipp
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 28 Dec 2020, 03:42
by Michael Power
Thanks Philipp.
Yes I found it strange too, that's why I ran with it.
Apparently, they were white until about 1942, then started using the USAF Olive Drab with yellow lines around them that were used in the ETO. Must have been a supply thing.
Michael
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 28 Dec 2020, 03:46
by Michael Power
I meant to say light grey not white.
Michael
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 28 Dec 2020, 07:47
by Adam Durrant
They look great Michael, I would assume the salt air would rust things up pretty fast.
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 28 Dec 2020, 12:25
by Michael Power
Adam Durrant wrote: ↑28 Dec 2020, 07:47
They look great Michael, I would assume the salt air would rust things up pretty fast.
Thanks Adam.
It certainly would not have helped as the bombs were stacked and man-handled and the box fins were in crates to protect the fins I believe.
Michael
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 11 Jan 2021, 07:24
by Michael Power
For quite a while now I have been contemplating trying my hand at Black Basing. I'd only heard of this when I came across videos from Doog's Models and became fascinated with the effect and started doing some research. Then I started to try out this technique with terrible results. The thing I found the hardest was the Tri-Colour paint scheme I wanted to use. I could not get a good mottled effect in a consistent manner through all colours using black as the base. So I eventually settled on a light grey primer overall and used differing tones of colour.
Unfortunately, this process to all my patience and a few resprays and I didn't take any pics of the hiccups. This is where I ended up so far.
- Left_Wing_1.jpg (65.45 KiB) Viewed 6249 times
- Right_Wing_1.jpg (64.8 KiB) Viewed 6249 times
- Fuselage_5.jpg (36.55 KiB) Viewed 6249 times
- Painting_3.jpg (66.85 KiB) Viewed 6249 times
- Fuselage_1.jpg (37.21 KiB) Viewed 6249 times
- Fuselage_4.jpg (36.54 KiB) Viewed 6249 times
The upper part of the fuselage is still in the grey primer with some of the experimental pre-shade as well. I'm not sure what Mr. Doog would think, but it's just my interpretation of his Black Basing method.
That's it for now. Will be back with the top soon, hopefully.
Michael
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 12 Jan 2021, 21:37
by Philipp Gross
Never heard of this method, so it's basically elaborate pre-shading?
In any case, I'd say it turned out fine
Philipp
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 13 Jan 2021, 00:15
by Vincent Power
Black Basing is very prevalent in aircraft builds Philipp, mainly because it's effective at creating visual interest on unbroken surfaces like wings and fuselages. I like the results you can get with it. AFV's have angles and smaller flat surfaces which are well served with existing modulation techniques.
Looking good Michael
Vincent
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 14 Jan 2021, 00:06
by Michael Power
Philipp Gross wrote: ↑12 Jan 2021, 21:37
Never heard of this method, so it's basically elaborate pre-shading?
In any case, I'd say it turned out fine
Philipp
Philipp, here is a link which will explain the technique far better than I can.
https://doogsmodels.com/2014/07/03/tech ... ck-basing/
Michael
Re: 1/32 Trumpeter F6F-3 Hellcat
Posted: 28 Jan 2021, 05:18
by Michael Power