Tiran 4

[Gary Boxall]

Tool holder brackets are added next - tie down loops are made from .010 lead wire. Tools will be left off....



Tie down loops on the rear basket are typically flat profile being PE so these have been replaced, again using .010 lead wire....



Gary

[Gary Boxall]

No 2 of 3 stowage boxes on this fender....



WIP....



Gary

[Shawn Ramsey]

In aw as usual.

Shawn

[Vincent Power]

I agree with Shawn. You are setting the bar so high Gary, I can hardly see it !!
Seriously good stuff.

Cheers,
Vincent

[Gary Boxall]

Thanks guys

Bit more progress. Once the padlock loops are added....



The main body of the latches are then added...



I drilled out the holes so I could use 5amp fusewire for the pins.

Gary

[Steve Hutchinson]

Stunning Gary,

Perhaps a Cold Basement style You Tube clip on the production of a Gary "" the Brass" Boxall box?

Vincent, be careful on the scaffolding, it must be way off the ground if you can see Gary's bar

Just superb work

Steve H

[Gary Boxall]

Thanks Steve. I'd need to find a way of fitting the optivisor to the video cam to do that


The lid is done and in place. Last on the list are the latches. The PE loops are too flat and square for my liking so I'm replacing them with 5 amp fusewire. First side done....



Gary

[Olivier Carneau]

Just stunnig !
Don't tell me you have soldered all those tiny parts

[Vincent Power]

Vincent, be careful on the scaffolding, it must be way off the ground if you can see Gary's bar
Steve H

[Gary Boxall]

Just stunnig !
Don't tell me you have soldered all those tiny parts

Okay, I won't tell you that then (Yes, they are)

Done and fixed in place....



Water can holder attached to front fender....



Gary